Trying to clean up my clean tone
Trying to clean up my clean tone |
Music Man Amps Discussion Forum » Adjustments, Maintenance & Calibration » Trying to clean up my clean tone
Author | Message | ||
Nicholas Tripodi (tripodi) Username: tripodi Registered: 01-2007 |
Hi Everyone, |
||
Mike Kaus (mm210) Username: mm210 Registered: 05-2006 |
Not really familiar with the RD's as far as controls but if the "gain" is a master volume, try it on 10 and the channel lower. That should clean it up. Mike. |
||
Mike (mike_h) Username: mike_h Registered: 06-2006 |
I have an 1x12 RD 65 and mm210 is correct! if this doesn't clean it up..... |
||
Mike (mike_h) Username: mike_h Registered: 06-2006 |
oops, i have an RP, which is the same as far as this discussion. |
||
Nicholas Tripodi (tripodi) Username: tripodi Registered: 01-2007 |
I was wondering if there was a way to get my gain to roll on smoother - Is it something to do with the pot? at the moment there is no increase in gain till about 3.5 then all of a sudden it kicks in quite loudly - perhaps if i can smooth this i might be able to find a cleaner tone at a decent volume level.. any thoughts? |
||
Mike (mike_h) Username: mike_h Registered: 06-2006 |
sounds like the pot is dirty. does it also sound scratchy when you adjust it? with the amp off, twist it back and forth several times and see if that helps. might need to spray some contact cleaner in the pot. it shouldn't kick in suddenly. it's probably dirty or possibly bad. good luck |
||
Nicholas Tripodi (tripodi) Username: tripodi Registered: 01-2007 |
thanks for the helpful advice - is pot cleaning something someone with little amp servicing experience can do? any tips on how to do it or contact cleaner recommendations? |
||
Mike (mike_h) Username: mike_h Registered: 06-2006 |
Well, yes it's very easy to clean the pots, but anytime you have the chassis removed from the amp cabinet, you are exposed to very high voltage, with most Music Man amps 700+ volts! So, if you accedentaly grab or touch the wrong, it could be lethal. If I were in your situation, I'd try twisting the knob back and forth lots of times. This can kind of clean the pots and see if this helps. Tubes amps can be very dangerous. Find a good tech in your area, a cleaning shouldn't be much at all, if that's the problem. |