Footswitch for MM sixty/five Reverb Head

hedgerow_2001

Bought a MM Sixty-five Reverb head today for $350. The reverb is not working... but the foot switch was not hooked up. Hoping it was because it was switched off. Would someone confirm that Red is reverb??? I assume it is since there is a red dot next to the hole labeled Reverb. Thanks

Full Name
Lars Verholt
Music Man Equipment
HD-130 head, 210X cab, 210RH cab, RD-50 110 combo, Sixty-Five 112 combo, RP65-112

Member for

11 years 7 months

lmv Sat, 06/23/2018 - 19:48

Correct, red dot jack is reverb. However, the reverb will be on if the foot switch is not hooked up (the same is true for the tremolo). There are a few reasons why the reverb would not work, and I can recommend looking through similar threads on this forum for more troubleshooting steps and results. Both the send and recovery stages inside the amp have to work, the cables to and from the reverb tank must pass signal and the tank itself must work too. The tank may have a bad connection or a broken wire inside - a very common issue.

Cheers,
Lars Verholt

Profile picture for user hedgerow_2001
Full Name
Keith Forman
Music Man Equipment
MM 115 65 Combo, 2005 Fender AS Tele, 1978 Gibson LP Standard, Epi Dot with 57 Classic p/us and Sperzel tuners, 1986 Marshall 4010 combo, 1990s Peavey Classic 50 with 4\10 cabinet, Martin HD 28, 1965 Fender Vibro Champ, Peavey Classic 20MH with 1/12 Cabinet, a million guitar pedals, ok that's enough

Member for

7 years 4 months

hedgerow_2001 Sun, 06/24/2018 - 06:10

Thank you Lars. I have talked to owner of music store and he said he will take a look. If he can't fix it, I know an amp guy that is very good, would be surprised if he could not remedy the problem. The amp still sounds amazing even without the reverb...

Subscribe to this forum topic